CC TROLLEY TRACKS
For CC containers | Danish trolleys | Transport carts
Manufactured entirely from recycled post-consumer cable sheathing
The practical alternative to concrete slabs
with integrated wheel guides
The idea is a practical trolley track made of smooth-running plastic. It serves as a walkway plate for customers, or as a sliding surface for CC trolleys or transport carts. The plastic plate is extremely easy to lay.
Furthermore, the surface this solution is laid on does not have to fulfil any special requirements, making it a high-quality alternative to concrete path slabs. The material used is characterised by durability, elasticity, noise insulation and weather resistance. Its low weight of 18 kg allows you to lay the trolley tracks by hand or move the ground plates to adapt to changes in logistics paths – a real challenge when using concrete slabs.
Furthermore, the surface this solution is laid on does not have to fulfil any special requirements, making it a high-quality alternative to concrete path slabs. The material used is characterised by durability, elasticity, noise insulation and weather resistance. Its low weight of 18 kg allows you to lay the trolley tracks by hand or move the ground plates to adapt to changes in logistics paths – a real challenge when using concrete slabs.
CC Trolley Tracks in use
Technical data
CC Trolley Tracks
18 kg
Weight
1,20 m
Length
Length
51 cm / 54,5 cm
Usable width / outer width
Usable width / outer width
25 mm
Ground depth
Ground depth
25 mm
Height of wheel guides
Height of wheel guides
100 %
Recycled plastic
(post-consumer PVC)
Recycled plastic
(post-consumer PVC)
Ramps for CC Trolley Tracks
1,35 kg
Weight
Weight
54,5 cm
Length
Length
11 cm
Width
Width
25 mm
Plate thickness
Plate thickness
Top/bottom
Versions
Versions
100 %
Recycled plastic
(post-consumer PVC)
Recycled plastic
(post-consumer PVC)
Laying instructions
Mobile:
- Level surface if necessary
- Lay ribbon fabric
- Observe integrated expansion joint of 5 mm
In cold conditions: lay with ~ 5 mm spacing
In warm conditions: lay with ~ 2 mm spacing
Stationary on non-reinforced surface:
- Min. 3 to 5 cm fine gravel (2 – 5 mm) as levelling and stabilisation layer
- Level surface
- Lay ribbon fabric
- Observe integrated expansion joint of 5 mm
In cold conditions: lay with ~ 5 mm spacing
In warm conditions: lay with ~ 2 mm spacing
Note:
- Easy to cut to size using a circular saw (carbide blade)
- Pay attention to expansion joints
Linking can be combined with Multikett
Multikett L, top side
Multikett L, underside
Multikett L, perforated, top side
Multikettt L, perforated, underside
Multikett S, coin profile, top side
Multikettt S, coin profile, underside
Multikett S, stone profile, top side
Multikett S, stone profile, underside